2N
3CX
AVLinkPro
AVProEdge
Aldous Home Networks
Araknis Networks
Aten
Axion Lighting
Binary
BulletTrain
CasaTunes
Cerasonar
ClareVision
Cleerline
Coolautomation
ELAN
Episode
FrenchFlair Audio
Frenetik Audio
Furman
Fusion Research
Kordz
Leviton
Luma
MSolutions
Murideo
NVT Phybridge
Nice
Penn Elcom
Platinum Tools
Proficient
Pulse Eight
Rako
SpeakerCraft
Spectre Acoustics
Strong
Sunfire
Triax
Visualint
WattBox
Wirepath
Xantech
Yealink
eelectron
SKU# :
A-100-DMX-CTRL-P
SKU
A-100-DMX-CTRL-P
The Axion DMX Lighting Controller enables you to fully integrate a DMX512 system via IP without the complexity of traditional expensive counterparts.
Now with firmware support to enable Wi-Fi!
Skip to the end of the images gallery
- Contact Us : Tel: +44 (0)1296 719 582 / Email: sales@aldoussystems.co.uk
Skip to the beginning of the images gallery
- Contact Us : Tel: +44 (0)1296 719 582 / Email: sales@aldoussystems.co.uk
This is a commercial grade solution designed to deliver unparalleled reliability with a specific focus on the best possible control integration possible. Specifically, the solution gives full exposure of DMX devices in Control4, Crestron, Elan, URC, and RTI systems. The overall solution is designed to give our partners highly flexible, modular installation options that can grow as needs and preferences change. (Latest Driver and Integration info - here)
The Axion DMX solution is primarily targeted at both tunable whites and RGB colors, but because it interacts using the DMX512 protocol it will also support many other commercial devices such as motors, lasers, smoke machines, and more.
*** Now supporting 16 bit mode in firmware 1.3.1 and above ***
Example Hardware Configuration
The pinout for the DMX controller is as follows:
1: Data +2: DATA –3-6: Empty7-8: Ground
Instructions
Axion PoE DMX Controller FW 1.5.0 – NOW SUPPORTS WI-FI
Once the controller has been connected to the network, you may either leave it DHCP, configure a DHCP reservation, or assign a static IP address. If you are integrating with Control4, the SDDP protocol is fully supported and the device will show up in the “Discovered” tab of Composer Pro. If you are using any other control system, it is recommended you either set a static IP or DHCP reservation in your router.
Operation
Factory Reset
To perform a factory reset, simply hold in the reset button, then apply power. This will reset the password to ‘password’ and revert the IP settings back to DHCP. It will also clear the Wi-Fi network association, which will put the Wi-Fi variant back into Wi-Fi setup mode (see above).
Password & Username
There is no username, leave this field blank. The default password is “password”. It is highly recommended that you change the default password via the local UI to maintain the utmost security. This same password is used when integrating to the control system and should be updated in any drivers or modules you are using.
SKU | A-100-DMX-CTRL-P |
---|---|
Warranty | 2 Years |
Write Your Own Review
More from Axion Lighting